Hydraulic testing and certification – Bench testing with RINA reports

---

Certified bench testing

TFS Oleodinamica performs functional testing on a Bosch Rexroth-approved test bench: verification of nominal and volumetric flow rate, measurement of differential pressure, leak testing, and recording of performance curves. Each test produces a signed and traceable technical report.

---

What we verify during testing

1. Nominal and volumetric flow rate – verification of the flow-pressure curve under design conditions
2. Differential pressure – measurement and comparison with the manufacturer’s rated values
3. Static and dynamic seals – verification of no leaks at maximum operating pressure
4. Noise and temperature – testing with calibrated instruments within the manufacturer’s limits
5. Technical report – test graphs, measured values, and signature of the responsible tester

---

Bosch Rexroth Test Bench + RINA Certification

The TFS test bench is Bosch Rexroth-approved for testing pumps and motors up to 500 bar. For assembled hoses, burst tests, and components for marine and offshore use, TFS issues RINA certification: the test report includes the certificate number and compliance with applicable regulations.

---

Components Tested at TFS

TFS Oleodinamica performs testing on pumps, motors, and components from leading manufacturers, using validated procedures and with original spare parts available in case of non-compliance.

---

For certification testing on pumps, motors, or assembled hoses, contact the TFS laboratory with the component details: testing schedule within 48 hours.